Installation of an ice maker water line is a reasonably simple challenge that a handyman can entire in an hour or in the event that they have a little expertise and the proper set of gear. However, there are some matters that could pass awry and reason damage to your property if no longer finished well. Even some unique set up kits and tools can lead you within the incorrect path, inflicting leaks in the future.
Installing an ice water line installation maker water line is an smooth process to do by way of yourself. In the beyond, you may only use a ¼” copper pipe to attach the ice maker to the nearest source of water, nowadays there are ¼” flex pipes that come in special lengths from 1′ to twenty’ that you can use to connect with any water source. You handiest want to calculate how a ways your water line will want to be run in order to buy the pipe with the proper length.
Most people run water strains via their shelves and over the refrigerator, however if that is not feasible, then you definately would possibly must look at walking the road through the floor. Most cutting-edge ice makers have a deliver valve, which makes jogging an outside ice maker water line smooth.
If you’ve got a water deliver
All you will want to do is to buy a brief 1/four” by using 1/4″ flex line and join it to the again of the ice maker after which to the supply of water. Once you have got performed that flip the water on and test for any leaks alongside the line.
If you don’t have a water deliver
If you need to feature a water deliver use both a brand new three-way perspective stops or add Adapt-A-Tee. There are Adapt-A-Tees which might be to be had from most plumbing stores that you may use. They are quick to install and require less paintings than most. Here are some steps that you can follow to install a new ice maker water line whilst there may be no water deliver:
– Locate the angle stop round or beneath the sink location where you’ll be tying the road. Close the tap and shut off water to the attitude forestall.
– Make certain that you disconnect the flex line strolling from the angle forestall. You might ought to use two units of pliers to cast off the road correctly. Pliers have to be used to connect the attitude stop and hold it in place, and the alternative must be used to unscrew the flex line.
– Now, you could attach the Tee Adapter. The adapter should connect with the water forestall valve and it have to be sized to suit the valve. The vital aspect is to make sure that the outlet has ¼” OD.
– Tighten the Adapt-A-Tee to the angle stop. Tighten it as tons as you could and use a wrench when you have to but be careful not to move the angle prevent at the same time as you are tightening.
– Reconnect the water supply line to the 3/eight” quit of the Adapt-A Tee. Hold it as you tighten the line connection.
– Connect the ¼” flex line to the Adapt-A-Tee and tighten.
To join the flex line walking from the water source these are the stairs you need to observe:
– Take the other stop of the ¼” flex line and join that to the ice maker. Tighten it using pliers to make sure that there are no leakages at that give up.
– Once the connections to the prevent valve beneath your sink have been secured, open the faucets on and run water via.
– Check for leaks at all the connection factors and along the road. If there are no leaks, your ice maker water line turned into effectively run and you can now positioned the ice maker lower back. You will must allow the water run through the ice maker or water dispenser (if you have one). You will want to try this to flush the road and dispenser smooth in addition to to dispose of any air trapped alongside the road. Use the water dispenser to do this. If you do now not have a water dispenser you need to throw out the primary full batch of ice that comes via the ice dispenser to make sure that the ice is easy.